|
||
| 'Manufacturers of Digital Power Analyzers, Digital Wattmeters, Harmonic Power Analyzers, Wideband Spectrum Power Analyzers, ATC Ohmmeters, Micro-Ohmmeters, Milliohm-Meters, Digital Ohmmeters, Igniter Testers, Current Calibrators, AC-DC Active Current Shunts, Hipot Testers, Body Comp Scales and more…' |
 | |||||||||||||||||||
|
 |  | DIGITAL IGNITER TESTERS |
|
Valhalla 4314AF User Safe Digital Igniter Tester
|
|||||||||||||||||||||
 4314AF Digital Igniter Tester |
Valhalla 4314AF Digital Igniter Tester Features Include:
|
||||||||||||||||||||
|
|
|||||||||||||||||||||
 |
 |
||||||||||||||||||||
|
|
|||||||||||||||||||||
|
With the 4314AF Valhalla introduces an added safety feature that prevents the possibility of having the charging adapter connected while using the instrument for measurements. A 6-pin Mil-Spec circular connector (MS3112E10-6S) on the front panel of the 4314AF replaces the four-terminal banana jacks used on the 4314A front panel and the battery charger jack on the 4314A rear panel. This is accomplished by the removal of the rear panel charger jack and including its connections to the instruments charging circuits through the 6-pin front panel connector. Four of the front panel connector pins are used to mate with the measurement adapter cable and the other two pins are for the battery charging cable adapter. By using separate adapter cables for measurements and charging of the batteries, it ensures that the charge circuit can not be activated at the same time as measurements are being made. Measurement Adapter Cable: The measurement adapter cable is a 3 feet long cable with a 6-Pin Mil-Spec circular connector, "MS3116F10-6P" at one end and a 4-Pin Mil-Spec circular connector at the other end. The cable configuration is two twisted pairs with an outer shield. The four wires are connected to four of the connector pins that mate with the front panel connector pins used for 4-wire measurements. Battery Charging Cable: A standard 115VAC input wall adapter with an output of 6VDC at 300mA is used for charging the 4314Af batteries. The adapter has a 3 feet cable that the 6-Pin Mil-Spec connector has been attached to. Removing the measurement cable from the 4314AF and connecting the 6-Pin connector of the power adapter cable to the 4314AF front panel connector allows the batteries to be charged. |
|||||||||||||||||||||
| Specifications: | |||||||||||||||||||||
|
|||||||||||||||||||||
| Customer safety engineered versions with specific ranges and fail safe current levels are available: Contact Valhalla Sales Department for assistance. | |||||||||||||||||||||
|
|||||||||||||||||||||
|
|
|||||||||||||||||||||
| BACK TO LIST |
|||||||||||||||||||||
A